MIMAKI SINGAPORE PTE. LTD.

Disable heater after unattended printing finished

  • Set ""STANDBY" time" and ""OFF TIME"" of the heater temperature setting.* This information is valid only during printing.

""STANDBY" time" sets the duration before entering the preheated state.
The preheated state has a temperature lower than the preset temperature of each heater by 3°C to 5°C.

""OFF TIME"" sets the duration before turning off the heaters.
The machine enters each state after staying for the time set as above.

* The "STANDBY" or "OFF state" will go back to the preset temperature when receiving print data or a key operation.



● When setting heater time on the JV34-260 main unit

For how to set the heater time on the JV34-260 main unit,
see "OPERATION MANUAL " -> "Extended Functions" -> "Changing the Set Values of the Heaters."

* To use the values set on the JV34-260 main unit panel,
select [Printing Condition] -> [Print Mode] in the job editor of the RasterLinkPro series.
Then, select [Panel Setting] in "Heater Standby" and "Heater OFF".

● When setting heater time in the RasterLinkPro series

For how to set the heater time in the RasterLinkPro series,
select [Printing Condition] -> [Print Mode] in the job editor. Select [User Definition] in "Heater Standby" and "Heater OFF", then set the time.



Return to Content

PAGETOP