1. Other Useful Functions

Preventing Uncut Media [OVER CUT/CORNER CUT]

Overlapping the start and end points can prevent the sheet from being left uncut. Configure this setting for very flexible sheets. Setting too large a value will result in cut prints. Perform test cutting and adjust the setting accordingly.

OVER CUT

The machine cuts the media in front of the cutting start point by the set value. The media is overcut by the set value at the end point.

OVER CUT: OFF

Over cutting figure 1

OVER CUT: 0.1 to 1.0 mm

Over cutting figure 2

CORNER CUT

When the OVER CUT setting value is entered, CORNER CUT is displayed. The machine performs over cutting at corners other than the start and end point.

CORNER CUT: OFF

CORNER CUT: ON

Corner cutting figure 1

Corner cutting figure 2

  1. Press the [FUNCTION] key in local mode.
  1. Use updown jog_ to select [SET UP], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [OVER CUT], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select the [OVER CUT] setting, then press the [ENTER/HOLD] key.
  • Settings: OFF, 0.1 to 1.0 mm (in 0.1 mm increments)
  1. Use updown jog_ to select the [CORNER CUT] setting, then press the [ENTER/HOLD] key.
  • Settings: ON/OFF
  1. Press the [END] key several times to exit.