1. Information Display Screen

For plotters

The information display screen is arranged as follows:

Plotter information screen configuration_
  1. [Model Information]
    The model name, serial number, and firmware version

  2. [Status]
    The current printer/plotter status*2

  3. [Tool Information]
    Type of tool installed

  4. Icons of tools attached to stations A - D are listed from left to right.
  5. The following icons may be displayed.
    Cutting Tool Icon List_
  6. Tool name abbreviations appear below the icons.
    Active tools are indicated by a tool icon outlined in green, with tool details listed below.
    • Station name
    • Unit name
    • Tool name (full name)
    • Cutting conditions
      The cutting conditions shown vary by tool.
      For more information, refer to the operation manual for the plotter.
    • Workpiece thickness
      Shows setting values in common to the CFX series.
      Unconfigured settings are indicated by [Not Set].
  7. Click [Cut Condition] to view a pop-up that lists cut conditions for all tools.
  8. [Camera Information]
    Indicates the current camera status.
    [Camera Information] is not shown unless a camera is attached.

  9. Camera Information_
  10. [Continue Mode Setting]
    Indicates whether continuous mode is enabled and the status.

  11. [Vacuum Information]
    Indicates vacuum status, as follows.

    • In operation
    • Stop
    • Error
  12. Notifications/Alerts*1
    Up to four can be displayed at the same time.
    If more than four messages are present, the display toggles through the messages at a fixed interval.

  13. Reload
    Refreshes the printer/plotter information on the app.

  14. Menu

  15. Model icon
    Click the icon to display the panel operation screen.

  1. The details displayed will vary depending on the model and status.

  2. The icon will vary as follows depending on the printer/plotter status.

Icon

Status

Explanation

Large not ready icon

Not Ready

The media has not yet been detected.

Emargency Stop

Plotter EMARGENCY switch pressed

Large offline icon

Local

Local idle status.

Busy

Function is currently being run.

Data Remain

Local idle status and data is being received.

Workpiece Thickness Not Set

Workpiece thickness has not been set.

Cutting Edge Not Detection

Cutting edge not detected in this state.

Large online icon

Remote

Remote idle status.

Remote Active

Printing or cutting is currently in progress.

Remote Wait

Printing/plotting is not possible as heater is currently warming up.