Dealing with Error Messages

Message	Corrective action
There is no printer/plotter reply.	Check that the printer/plotter power is turned on. Check that the cable is correctly connected and not damaged.
It can't connect to the printer/plotter	Select the reload button to update the printer/plotter list.
It can not connect because of the unsupported model	Check that the printer/plotter being used supports MRA. MRA Usage Conditions
It cannot connect because of the unsupported F/W version	The firmware version used is not compatible withMRA. Update the firmware to the latest version.
Registered favorites have reached the upper limit: 20	Up to 20 printers and plotters can be saved as favorites. Remove any unnecessary printers or plotters from the favorites. Removing a printer/plotter from favorites
Invalid PIN Code	The PIN code entered was incorrect. Check the PIN code set in the printer/plotter main unit settings. Checking and Setting PIN Code
Please enter a 4-digit integer (0000 cannot be used)	Check that a four-digit PIN code was entered. If the PIN code set in the printer/plotter main unit settings is "0000", enter any four-digit number between 0001 and 9999. Checking and Setting PIN Code
Connection is not allowed	Remote control is not permitted under the printer/plotter main unit settings. Alter the main unit settings. Checking and Setting PIN Code
It can't connect to the printer. Please check the network environment	Check that the printer/plotter power is turned on. Check that the cable is correctly connected and not damaged.
Panel operation can't execute because another device is controlling the printer. Please exit Mimaki Remote Access which is using now.	The panel operation screen can be opened from only one device at a time.
Connection of printer/plotter has released.	Communication was canceled due to the printer/plotter key life time elapsing or the Enter key being pressed. To reconnect, select [Reconnect] in the dialog that appears.
There is no printer/plotter reply. Please check the network environment	Check that the printer/plotter power is turned on. Check that the cable is correctly connected and not damaged. Check that the remote control status of the printer/plotter is canceled.Canceling Procedure when Printer/Plotter LCD Screen is in Remote Control Mode To reconnect, wait about 3 minutes after connecting to the network, and then select [Reconnect] in the dialog that appears.
It can't connect to the printer/plotter. Please check the printer/plotter settings	Check that the cable is correctly connected and not damaged. To reconnect, select [Reconnect] in the dialog that appears.
Enter between 1 to 60 seconds	Enter an integer between 1 and 60 for the LCD screen update frequency setting. Setting Up MRA